 |
#5D 1 3/4 long Box Nails
Good for nailing wagon floor
down.
171 nails per
pound
Order #
CX-5
| 1 pound box |
$16.50 |
| 5 pound box |
$45.90 | |
Authentic Old Time Cut Nails
From the worlds oldest nail
manufacturer.
Making nails the old
fashion way since 1819.
We can
furnish most any style or size.
Email us your needs.
|
#7D 2 1/4 Long Clinch Rosehead
Clinch means the nail is
malleable enough to be bent over. Good for nailing the 1x4 corner
braces of the wagon bed side boards
120 nails per pound
Order #
CLR-7
| 1 pound box |
$16.70 |
| 5 pound box |
$56.65 | |
|
|
Wheel Nuts - We
have to know if you want left hand or right hand.
The skeins these fit are approx. 1 3/4 inch diameter.
$25.00 |
|
Wheel Wrenchs
Different Sizes, all are rusty.
Tell us the width you need.
$15.00
If we don't have the size you
need we can make you a new one in our Blacksmith Shop. We would need
a wheel nut to make sure it fits good. A welded wrench runs $30.00
and a riveted wrench would run $35.00. These would be exact replicas
patterned after wrenches we have on hand.
Please
email us the size you need before ordering so we can check and see
if we have that size.
|
Kingpin
Usually have several on hand.
Some worn more than others but solid
and ready to use.
$15.00 |
|
|
Heavy Tongue Cap
With Safety
Nipple.
Exact replica of original.
Made in our Blacksmith
Shop
$55.00
 |
|
|
Bow Staples
Fits our 1/2" x 2"
bows.
Note: Bows must be
tapered by hand to fit in the staples. These are made this way so
the bows won't slide too far through the staple.
$1.59 each |
|
 |
Brake Shoes
Made from White Oak or Hickory. Metal shoe clip not included but you must send us
both of your clips. They are
not always identical. We make the shoes to fit your clips. We also
need a piece of cardboard with the curve of your wagon wheel traced
on it.
$130.00 per set or $65.00 for one
shoe |
|
Stay Chains
Hand made the old time way in our
Blacksmith Shop. We don't know anywhere that you can buy brand new
stay chains and used ones are very difficult to find. You can't even
buy chain links like this anymore and even if you could they would
be zinc coated and not authentic to the wagon era. We hand forge
each link and hand forged the hook. These are exact replica of a set
of Springfield Wagon Co. Stay Chains that we have in our
collection,
$49.00 per chain
|
Seat Springs
1 1/2" wide x 24" long
Two leaf,
3 hole center mounting.
Full turned eye on bottom main
leaf.
Oil quenched and tempered in electric controlled
furnace.
Primed to prevent rust.
$57.00 each
|
|
|
Small
seat springs for childs wagon.
Measures 1 inch wide, 12 inches long, and 5 inches tall.
$75.00 per set.
|
|
 |
Covered Wagon Bows
1/2" x 2" x
14'
Specify if you want them to fit a 38" or 42" wide
bed.
$165.00
Bows can't be ordered through our
shopping cart because of the shipping problem. Please email your
order directly to us for shipping quote.
Email
order form
|
|
 |
Wagon Cover
13 ounce white polaris.
Flame retardant, mildew resistant and water repellent
Email us your measurements
for a quote.
Specify if you want Loops or Grommets.
Email us for quotes on larger sizes.
Allow 3 to 6 weeks for delivery.
We can furnish end flaps to seal the inside.
These tie to the bows.
We have to have a
measurement from the top
of the side board to the top of the bow.
|
|
|
Wheel Locks
Used to lock the back
wheel or wheels of a wagon on a very steep grade. The team would
slide the wagon downhill. We recently used a set of these on our
wagon on the original Cherokee trail in Wyoming. We traveled 100
miles over this old trail with a wagon train.
34 inches long.
Handmade links.
Measure your wagon and make sure this will fit.
We can custom make any size. The ring was placed over the floor
support rod, shown on picture and left hanging until
needed.
$95.00 each
 |
|
|
Rough Locks
20 inches
long
Exact replica of a Conestoga Wagon rough lock except
downsized to fit a standard wheel. Shown locked on top of wheel for
display purposes but it locks on the bottom of the wheel. Used in
conjunction with wheel locks on very steep grades to slow down the
sliding wagon and to help keep from wearing out the tire. Fits a 1
3/4 inch wide x 2 3/4 wheel. Handmade in our Blacksmith Shop. Can
custom make any size.
$95.00 each
An interesting historical note
is that it was against the law to use rough locks on the old
turnpikes because it tore the road up too bad.
|
|
|
Cover Hooks
The wagon cover ties to
these.
Handmade in our Blacksmith Shop.
Attach with a
carriage bolt or rivet.
Takes 18 for a wagon with a ten foot six bed.
These are attached between the eyelets
or loops, not directly under them.
$3.50 each |
| |
|
|
|
|
| |
|
|
|
Wrought Iron Foot and Hand
Ratchet
The only kind of brake to have on
your wagon in our opinion. This brake is handmade in our Blacksmith
Shop, the old time way and put together with rivets. An exact
replica of an original in our collection. One end of the brake rod
comes straight. You have to cut to length, heat and bend it to
attach to the handle.
Allow 4 to 5 weeks for delivery.
$350.00
Six
Hundred Recipes"worth their weight in gold"
published 1867.
Melt 4
ounces mutton-suet with 12 ounces beeswax; add 12 ounces
sugar-candy, 4 ounces soft-soap dissolved in water. and 2 ounces
indigo, finely powdered.
When melted and well mixed, add 1/2 pint turpentine.
Lay it on the harness with a sponge, and polish off with a brush.
|
|
 |
 |
|
|
Tongue Bolts
Two Styles. Sloped head and straight head.
Sloped head has a sloped washer with it.
Check your tongue hounds to see
which bolt it takes.
We
offer two lengths. 5/8 x 24 and 5/8 x 26, same price."
Flat Head $40.00
Sloped Head and Washer $50.00
|
|
 |
 |
.
